Home Services CVCcards Birthday Club FAQ Directions Contact
 
 

::Check it out!
 
 
 
 
 



 

 

:: Tips


Please note the following:

The first three buttons under the "stop" button are low pressure, very concentrated soaps used for cleaning tires, wheels and engines, cleaning bugs and road tar (magnesium chloride in winter) and a pre-soak solution. These low pressure soaps should be used to get the dirty areas wet, let the soaps work for at least 30-45 seconds, then spray off with the high pressure soap cycle.

It is the low pressure soaps that produce the best results if used correctly, as they are designed to loosen the dirt and road grime immediately.

If you need to clean your engine and/or tires and wheels, start with the engine first, then move on to the tires and work from left to right, starting with the left front wheel. It takes 15-20 seconds for the soaps to change and be delivered to the spray gun. By starting at the left front wheel, you can change the soap cycle just before finishing with the left rear tire.

Be sure to finish with the SPOT FREE rinse. This is pure water made inside the equipment room using a reverse osmosis system. It will not cause spotting on your car. This is also a low pressure spray.


     
 
Copyright © 2006 AnimasAutoSpa.com. All rights reserved.
HOME | SERVICES | CVC CARDS | BIRTHDAY CLUB | ABOUT | TIPS | FAQ | ENVIRONMENT | DIRECTIONS | CONTACT US | PRIVACY
 

 

Animas Auto Spa CVC Cards